A Guide to Tankless Water Heaters
A tankless water heater saves energy by turning off completely when no hot water is being drawn - there are no standby losses - no tank of hot water needs to be kept hot when hot water is not being used.
Although some instantaneous water heaters can provide up to 9 GPM (and use 200,000 BTUH), smaller units cannot provide very large hot water flow rates in gallons per minute.
If the hot water usage rate is expected to be high, a very high BTUH unit (efficient but not necessarily economical) or multiple smaller point of use tankless water heaters may be needed to satisfy all building occupants and uses.
Consumer Reports points out that a tankless water heater may be efficient but not necessarily economical to operate. What they mean is that it is certainly efficient to avoid heating water when no one is using it. But if water usage is high, a high-BTU tankless water heater may consume more total energy than a large but more conventional oil or gas fired hot water tank and burner.
As the name suggests, and as you can see in our photo at left of an electric Instant-Flow water heater, tankless water heaters have no tank, and therefore no storage capacity at all. When the faucets and fixtures in the home are idle, the water heater is dormant.
No stored hot water means no standby losses, and, if you match the heating capacity of your tankless heater to your hot water flow rate requirements, there is no delay in hot water supply and no running out of hot water.
The Instant-Flow® water heater shown is a Model S-48L/240 240-volt unit rated at 4800 watts and is installed on a 20-A electrical circuit.
Tankless heaters are supplied in all-electric models (shown here) and gas (or possibly oil) fired units that include a burner, heat exchanger, venting system, and the necessary controls.
When a hot water faucet is opened or the dishwasher or clothes washing machine calls for hot water, the tankless heater detects the water flow and ignites the burners.
These powerful burners quickly heat the water inside the small diameter heat exchanger. As hot water is drawn out, fresh cold water is drawn in and the cycle continues. A significant advantage of this system is that you can't empty all of the hot water out of the tank because there is no tank - just continuous hot water.
No Stored Water
The other major advantage over conventional water heaters is energy savings. Tankless water heaters have no large reservoir of water that has to be kept hot around the clock in case hot water is needed. One side effect of the lack of storage is that all of the water in the system is cold when the system has not been in operation recently. When a hot water faucet is operated, it may take more time for hot water to be delivered than in a conventional system.
As you can see by our photo (left) of an Ariston tankless water heater, tankless or demand or "instant" water heaters are much smaller than conventional waters with storage tanks, and are usually wall-mounted.
However for non-electric tankless heaters, the burner on a tankless or demand water heater must be much larger than on a conventional heater since it has to instantly heat incoming cold water to its target hot temperature.
Tankless Water Heater Fuel and Venting
Most tankless water heaters are either electric, or they are fueled by natural gas or propane and are vented through a side wall of the house.
As Rheem points out, "The venting must be Category III, Stainless steel, and it applies to the adapter, the vent pipe, all elbows, and terminal vent. This is important because the flue gases and by-products of combustion can cause condensation. Stainless steel will not deteriorate like type B venting under these conditions."
Tankless Water Heater Efficiency
Tankless water heaters are often much more efficient than conventional water heaters, using modulating burners, direct venting and/or condensing combustion systems.
Mixing Valves / Flow Control Valves used on Tankless Water Heaters
Most systems include a mixing (tempering) valve and a means of setting a maximum water temperature to avoid scalding. This tempering valve mixes some cold water with the hot water leaving the unit to reduce the temperature.
In one sense, there should be no need for a tempering valve, since we do not need to keep the reservoir water at 140° to prevent Legionnaires Disease.
On the other hand, since we don't know the flow rate of the water through the heater, the tempering valve may be needed since the burner cannot modulate to deliver exactly the temperature we want due to the infinitely variable water flow.
If the flow rate is low, the water moves more slowly through the heater, and picks up more heat from the burner.
Tankless Water Heater Remote Control
Some tankless systems include a remote control, which can be used to monitor the performance of the system, display error codes or change the desired water temperature.
-  Bosch Tankless Water Heaters - http://www.boschhotwater.com/
-  Chromolite Tankless Water Heaters
- Cinsa Hidro Tec Instant Water Heaters (Mexico)
-  Bradford White Everhot Tankless Water Heaters - Bradford White offers this step by step hot water retrofit installation file (large, slow PDF) - www.bradfordwhite.com
-  Eemax Tankless Water Heaters - http://www.eemaxinc.com/
-  Instant-Flow Water Heaters, Chronomite Laboratories, Inc., City of Industry CA 91774
-  Noritz Tankless Water Heaters - http://www.noritz.com/
-  Rheem Tankless Water Heaters - http://www.rheemtankless.com/content/
-  Rinnai Tankless Water Heaters - http://www.rinnai.us/tankless-water-heaters/
-  Stiebel Eltron Tankless Water Heaters - http://www.stiebel-eltron-usa.com/ (shown at above left)
-  Takagi USA Tankless Water Heaters - http://www.takagi.com/
-  Titan Tankless Water Heaters - http://www.titanheater.com/
-  Takagi tankless water heaters (shown at left) and Takagi radiant heat systems: Takagi combines both radiant heating for floors and domestic hot water production. Takagi offers pre-assembled radiant heating system installation packages including for do-it-yourself'ers, and including systems that combine radiant heat flooring with domestic hot water production using a gas-fired tankless water heater. See takagi.com for more information."The T-KJr model (gas inputs up to 140,000 BTU per hour) is the smallest unit in the Takagi line-up. The T-KJr is perfect for light residential (i.e. small apartment units) and radiant heating applications." Image at left is the Takagi T-K3-SP tankless water heater intended for light residential applications, image courtesy of Takagi Corp.
Also see RADIANT HEAT Floor Mistakes to Avoid where we describe use of small boilers or tankless coil type water heaters for radiant floor heating systems.
Readers should also see ALTERNATIVE HOT WATER SOURCES to distinguish among these types of hot water producing systems and see ELECTRIC SHOWER HEATERS for a discussion of point of use heaters at shower heads.
The original text of this article was provided courtesy of Carson Dunlop - that text has been edited and may not entirely reflect CD's views. Page top sketch of a point of use tankless water heater courtesy of Carson Dunlop Associates. Our OPINION is that readers looking for plenty of hot water heated efficiently should also consider the heater we describe at Indirect-fired Water Heaters.
Green link shows where you are in this article series.
- ELECTRIC SHOWER HEATERS
- GAS BTUH, CUBIC FEET & ENERGY
- HOT WATER DELIVERY SPEED-UP
- TANKLESS COILS
- TANKLESS WATER HEATERSWATER HEATERS - home
Tankless Heaters for RV's